5
8
STANDARDS
This model is eligible to bear the CSA mark shown with
adjacent indicators “C” and “US”. The “C” and “US”
indicators adjacent to the CSA mark signify that the product
has been tested according to the applicable CSA (CDN)
and ANSI/UL standards for use in Canada and the USA.
This includes products eligible bear the designation NTRL.
NTRL (Nationally Recognized Testing Laboratory) is a desi-
gnation awarded by the American Occupational Safety and
Health Administration (OSHA) to laboratories authorized to
award the certification according to American standards.
11
LIMITED WARRANTY
This SFA appliance bears a 3 year warranty starting from
the date of purchase, subject to proper installation and use,
in compliance set out in this notice.
Warranty issues will be handled by the Technical Department
and will be subject to correct installation and usage.
If a replacement is to be issued, this will be only extended
to the first 180 days starting from the date of purchase
and will need to be approved by one of our company’s
representative. Warranty repairs will apply after such date
up to the warranty’s date of conclusion.
Plumber’s invoices for any type of repair, disconnection and
reconnection are not covered by the warranty and are the
end user’s responsibility. In no event shall the company be
liable for any special, incidental or consequential damage,
loss or injury of whatsoever nature or kind arising from or in
connection with the product or any component thereof.
10
TROUBLESHOOTING
Disconnect the electrical supply before carrying out any work.
FAULT DETECTED
• The pump does not start
• The pump does not lift
PROBABLE CAUSES
• The pump is not
connected to the power
supply
• The locking pin has not
been removed.
• The unit is not level.
• Power cut
• Float blocked
• Condensates inlet pipe
blocked
• Non-return valve blocked
• Discharge pipe blocked
ACTION NEEDED
• Plug in the unit.
• Remove the locking pin.
• Please check the unit
with a spirit level.
•
Check the mains voltage.
• Clean the SANICONDENS
®
tank
.
• Clean the SANICONDENS
®
inlet pipe
.
•
Clean the valve.
• Clean the discharge pipe
.
INSTRUCTIONS RESERVED SOLELY FOR
QUALIFIED PROFESSIONALS
OPTIONAL: if you connect the brown and black wires to
the control relays on your boiler, it will be switched off if the
water level rises too high in the unit.
ATTENTION: The maximum current admissible for our
detection system is 0.5A.
To protect the electrical components in the
SANICONDENS
®
, once the alarm has been triggered, any
water continuing to fill the tank comes out through the over-
flow outlets in the cover.
BEFORE TURNING THE DEVICE ON, MAKE
SURE YOU REMOVE THE PROTECTIVE LOCKING PIN
FROM THE REAR OF THE DEVICE
7f
EXAMPLE OF AN INSTALLATION OF
A SANICONDENS
®
: see fig.
7f
9
DISASSEMBLY
If a breakdown occurs, any service on the unit should be
carried out by a qualified technician. In particular the
replacement of the power cable.
Disconnect the electrical supply before carrying out
work on the unit.
INSTRUCTIONS INTENDED SOLELY FOR
QUALIFIED PROFESSIONALS
7e
9420 249 SANICONDENS.indd 59420 249 SANICONDENS.indd 5 05/04/11 11:0305/04/11 11:03
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals